How Do You Remove the Drain Cap on a John Deere X300?

Step 1: Park the lawnmower on a flat surface, turn off the engine, and engage the parking brake.

Step 2: Jack up the rear of the lawnmower. Place a block of wood or metal under the front axle for support.

Step 3: Locate the drain cap on the bottom of the oil pan. It is usually a black or silver plastic cap with a 17mm hex head.

Step 4: Use a 17mm wrench to loosen the drain cap. Avoid dropping it into the oil pan.

Step 5: Allow the oil to drain into an oil pan until it stops completely.

Step 6: Replace the drain cap and tighten until snug.

Step 7: Remove the support block and lower the lawnmower.

Step 8: Dispose of the old oil at a recycling center or according to local guidelines.

Step 9: Refill with new oil using a funnel. Check that the level is between the “full” and “add” marks on the dipstick.