Where Do You Add Hydraulic Oil in a John Deere 2240?

Adding Hydraulic Oil to a John Deere 2240

  1. Locate the hydraulic oil reservoir. This is usually a large, cylindrical tank with a black or red cap, located on the left side of the tractor near the rear axle.
  2. Remove the cap. Be careful, as the oil may be hot.
  3. Add hydraulic oil. Use a funnel to avoid spilling. The level should be between the “full” and “add” marks on the dipstick.
  4. Replace the cap.
  5. Start the tractor and run it for a few minutes. This circulates the oil and mixes it with the old oil.
  6. Check the oil level again. Add more if it is low.

Additional Tips

  • Use John Deere Hy-Gard Hydraulic Oil.
  • Do not overfill, as foaming can damage the hydraulic system.
  • Check the oil level regularly.
  • Change the oil every 1,000 hours of operation.